Motor DC Johnson RD356X30 PM Permanent Magnet Bronze Bearing Belt Gear Precision

This is a shielded, PM Permanent Magnet, high torque low Voltage DC motor. The 3.25 millimeter diameter shaft has an attached gear to drive cogged belts. Shaft is 12 mm long on the opposite end and also usable. Makes a good generator. Useful as a replacement motor or for a special project. Motor begins to rotate at 1.5 Volt while it's no-load current is around 0.05 Amperes. Additional numbers on motor: C3801-60005. This motor is able to drive many loads smoothly and with a small PM or stepping motor and a rubber band - as a belt - it would make a classy, precision, low distortion sine-wave generator, a simple generator with a small windmill or some other great science project. First come first serve. Only one available.
Motor DC PM Permanent Magnet Bronze Bearing Belt Gear Precision Johnson RD356X30 [7 KB]


DC Motor PM Permanent Magnet
MFR: Johnson Type: RD356X30
Permanent magnets Sleeve bearings
Solder terminals with wires and connector
Belt Gear attached
Motor begins to rotate: 1.5 VDC
Motor current: approx. 50 mAmp
Size: 37 Dia, 85 L [mm] (with shaft)
Weight: 220 Grams
Shaft size: 3.25 mm dia
Pulley Size: 10 mm dia, 8 Wide [mm]


Used Price: $30 One available
S/H included within continental US
Previous Page

Click to Order Only one item available unless otherwise indicated
Click the credit card pictures left to order
E-Mails always answered unless return e-mail is blocked
Copyright 2017 K Nagy - http://www.OddMix.com - All Rights Reserved
Page Revised: 2017-04-05 - - Privacy Policy - Site Map - Support